Q330

Upgrading Q330 firmware is done with the program Willard.

 

Setup: Download the required firmware from http://q330.com/ Place the firmware into a folder with the name of the firmware (in this example the folder name would be "1.80"). Note: This is important because all Q330 firmware files are named identically. To keep them separated, they must be stored in separate folders.

 

Willard:

Power up the Q330 and connect it to computer via console cable.

Start Willard and select console registration.

 

Select "No" if asked to create a dataless station.

 

 

 

 

Open the Windows control panel by pushing start button and then Settings and Control Panel.

 

 

 

Look under Ports (COM & LPT) to find the available com port numbers. In this picture we know that it is the “Keyspan” on COM 4 because we were using a Keyspan adapter.

 

If the Dataless Station panel appears select No. Otherwise proceed to the next step.

This page provides instructions for downloading Balers using the EzBaler program and reviewing the State of Health (SOH) data using PQL. EzBaler is the best option for downloading data from multiple Balers at one time. Known problems are: it will sometimes fail to connect to a Baler (just try again) and it will hang up if it encounters corrupted data.  These instructions are written specifically for use with a PASSCAL MacBook field computer, but in general apply to other platforms as well.

The data downloading is in two parts.  The first part is downloading the SOH data which contains the low sample rate seismic data and systems data to be used for doing field Quality Assurance (QA) for the station.  The second part is downloading all of the seismic data for archiving.

Quanterra Q330

Q330's are typically used for broadband standalone and telemetered real-time data recording. They have an external storage device (either hard drive or USB flash drive) and lend themselves for a variety of telemetered modes.

 

Reftek RT130

The Q330 is a 3 or 6 channel high resolution datalogger. It is low power and highly configurable for a wide range of applications and sensors. The Q330 is housed in a sealed aluminum enclosure which makes it highly resistant to the environment. Telemetry is a main focus of the Q330, but it also has a robust on-site data storage system which uses external Balers. This makes it easy to swap out the data storage on-site for when servicing doesn't allow an extended visit. The Q330 can write data to four different receiving systems simultaneously. It also has built-in sensor controls, an automatic mass recentering feature, and calibration functions. The Q330 is programmed with a Windows program called Willard, it can also be controlled by a PalmOS program for when working in the field.

Features: