Willard

Programming a Q330 with Willard

Willard is Quanterra's program to program and control Q330's. It is a standalone Windows program which allows you to set parameters, monitor data acquisition, storage, gps power cycling, sensor control, and much more. It is a very powerful and complex program which does not lend itself to a brief 'walkthrough' via a webpage.

Due to its complexity and ability to control every aspect of a Q330, it is very easy to make a severe mistake which would make the Q330 not function as intended. We highly recommend that only experienced users of Willard program Q330 parameters. You should contact a EPIC staff member if you have any questions regarding using Willard to program a Q330.

During training at EPIC, users receive a walkthrough of Willard.

 

Updating Firmware For Q330's

Upgrading Q330 firmware is done with the program Willard.

 

Setup: Download the required firmware from http://q330.com/ Place the firmware into a folder with the name of the firmware (in this example the folder name would be "1.80"). Note: This is important because all Q330 firmware files are named identically. To keep them separated, they must be stored in separate folders.

 

Willard:

Power up the Q330 and connect it to computer via console cable.

Start Willard and select console registration.

 

Select "No" if asked to create a dataless station.

 

 

Loading Programs From Laptop to Q330's

 

 

Open the Windows control panel by pushing start button and then Settings and Control Panel.

 

 

 

Look under Ports (COM & LPT) to find the available com port numbers. In this picture we know that it is the “Keyspan” on COM 4 because we were using a Keyspan adapter.

 

If the Dataless Station panel appears select No. Otherwise proceed to the next step.

Syndicate content