Clie

The RT130 can be configured using any PalmOS device that has a serial interface and the program PFC-130, but the EPIC exclusively uses and provides Sony Cliés.

The following is an example outline of an RT130 configuration using the PFC-130 program. The outline is intended as a quick reference guide only and is not a substitute for training or reading the official manufacturer's manual. For detailed information on programming the RT130 using PFC-130, consult the manufacturer's RT130 information page and brochure.

Note: Items marked with * are information that will be written to the log file, but will not affect the operation of the RT130.

To program a Q330 with a Clié you need to use either the "Q330 B147" or "Q330 1.491t" program. These programs can be found on the main menu of any Clié received from EPIC. These programs are used to send or retrieve parameters/configurations, change station names, change IP addresses, and to send commands to a Q330.

Important note: To program a Q330S (which is different from a normal Q330) you MUST use the program "Q330 1.491t"

This page is meant as a quick reference guide for using the Clié program "PFC-130" to load configuration parameters to a RT130. When deploying RT130's in the field, you will be provided an installation worksheet which covers the same steps but with more detail specific to your experiment.

1. Open PFC-130, on the Clié

2. Select Work with Configuration

3. Load (Load Configuration Pre-Written or Loaded Config File)

4. Select OK

5. Verify Configuration Name top of screen

6. Send to DAS

7. Select OK

8. Select Done

9. Re-Enter Work with Configuration

10. Select from DAS (Load from DAS)

11. Edit

12. Confirm Experiment Name